Parkside PASS 3.6 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 14

Anleitung_LB7_4513427:_
GB/
CY
8.5 Handle adjustment (Fig. 1.2/Item 3)
The screwdriver can be locked into 2 different
angle settings. To do so, press the locking
button (3) and move the screwdriver into the
desired position. Then release the locking
button (3).
Caution:
Before you switch on the screwdriver, make
sure that it is correctly locked in the required
angle position.
8.6 Battery capacity indicator
(Fig. 4/Item. 5)
Press the button for the battery capacity
indicator (6). The battery capacity indicator (5)
indicates the charge state of the battery on 3
coloured LEDs.
All LEDs are lit:
The battery is fully charged.
The yellow and red LED illuminate:
The battery has an adequate remaining charge.
Red LED:
The battery is discharged, it requires charging.
8.7 Changing the tool (Fig. 5)
Important.
Set the clockwise/counter-clockwise
changeover switch (10) to its centre position
whenever you carry out any work (for example
changing the tool, maintenance work, etc.) on
the cordless screwdriver.
Pull back and hold the locking sleeve (14).
Insert the bit (a) into the bit chuck (1) and let
go of the locking sleeve (14)
Check that it is properly secure by pulling
the tool.
For removal of bits (a), pull back the locking
sleeve (14) and hold it firmly.
Remove the bit (a) and let go of the locking
sleeve.
14
Downloaded from www.Manualslib.com
02.11.2010 9:37 Uhr
manuals search engine
Seite 14
8.8 Torque Setting (Fig. 1/Item 13)
Caution:
Only adjust the torque when the appliance is at
a standstill.
The cordless screwdriver is fitted with a
mechanical torque selector.
The torque for each particular screw size is
adjustable at the torque selector (13). The
required torque is dependent upon several
factors:
the type and hardness of the material to be
worked with.
the type and length of the screws used.
the physical burden placed on the screw
connection.
When the torque is reached, this is indicated by
the clutch being released.
8.9 Screws
It is advisable to use self-centering screws (e.g.
Torx, Philips head screws) as these will enable
you to work safely and reliably. Always make
sure that the bit used is of the same size and
shape as the screw.
8.10 Screwdriver overloaded
If the screwdriver is overloaded, the automatic
safety switch turns the device off. After a few
seconds the screwdriver can be used again.