Audiotec Fischer HELIX V TWELVE DSP Bedienungsanleitung Seite 33

On: Activation via highlevel speaker input is
enabled (ex works).
Off: Activation via highlevel speaker input is
disabled.
8. Configuration of the internal DSP
The general DSP settings should be con-
ducted with the DSP PC-Tool software be-
fore using the amplifier for the first time.
Ignoring this advice may result in damaging the
connected amplifiers / loudspeakers. Informa-
tion about connecting the V TWELVE DSP to a
computer can be found on page 36.
9. Connecting the loudspeaker outputs
The loudspeaker outputs can be connected
directly to the wires of the loudspeakers. Never
connect any of the loudspeaker cables with the
chassis ground as this will damage your ampli-
fier and your speakers.
Ensure that the loudspeakers are correctly con-
nected (in phase), i.e. plus to plus and minus
to minus. Exchanging plus and minus causes a
total loss of bass reproduction. The plus pole is
indicated on most speakers. The impedance of
the speakers must not be lower than 2 Ohms.
10. Connecting the remote output
This output (Rem Out) is used to supply remote
signals to the external amplifier/s. Always use
this remote output signal to turn on the ampli-
fiers in order to avoid on / off switching noises.
33