Audiotec Fischer HELIX V TWELVE DSP Bedienungsanleitung Seite 26

Connectors and control units
1
USB Input
1
Connects the HELIX V TWELVE DSP to your
PC.
Control Input
2
Multifunction interface for e.g. an optional
remote control or other HELIX accessory.
.
Control pushbutton
3
Use this button to either switch between the
setups or initiate a reset of the device.
Status LED
4
This LED indicates the operating mode of the
amplifier and of its memory.
Optical Input
5
Optical input for digital stereo signals (SPDIF
format).
Rem Out
6
The remote output has to be used to turn on /
off external amplifiers that are connected to
Output Channels
11
Speaker outputs for connecting speaker
systems.
GND
12
Connector for the ground cable (negative
terminal of the battery or metal body of the
vehicle).
REM
13
Connector for the remote cable of the radio.
26
2 3 5
4 6
11 12 13 14
8
7
the RCA / Cinch line outputs. Both connec-
tions are internally wired parallel.
Highlevel Input
7
Highlevel speaker inputs for connecting a
factory radio or an aftermarket radio without
lowlevel line outputs.
Line Input
8
RCA / Cinch
pre-amplifier signals.
Clipping LED
9
This LED lights up red if one of the analog
inputs is overdriven.
Gain
10
Control for adjusting the input sensitivity of
the lowlevel Line and Highlevel Inputs.
15
+12 V
14
Connector for the +12 V power cable to the
positive terminal of the battery.
Line Output
15
Line outputs
amplifiers. Make sure that the remote output
(Rem Out) is used to turn on these devices.
9
10
inputs for connecting
11
for connecting external