Balluff BES M12EH1-L01C40B-S04G-L04 Anleitung Seite 137

BES M12EH1-L01C40B-S04G-L04 / BES M18EH1-L01C80B-S04G-L04
Inductive sensors
5
Secondary Device Functions (continued)
Speed Lower Limit Low
In combination with Speed Lower Limit High, it forms a
threshold value with hysteresis for the too low status.
Speed Monitoring Startup Delay
With Startup Delay, the time for the startup delay can be
set. The startup delay begins after the supply voltage is
switched on. During the startup delay, speed monitoring
has no function. Speed monitoring starts after the startup
delay has elapsed. The value represents the time in
seconds. The value range is between 0x00 (0) and 0xFF
(255). A value of 0x00 (0) represents no start delay.
Speed Monitoring State
With Speed Monitoring State, the current status can be
read.
Value Meaning Description
0x00 (0) Idle No speed value yet available
0x01 (1) Too low Speed value is less than the
lower threshold
0x02 (2) OK Speed value is in the suitable
range
0x04 (4) Too high Speed value is greater than
the upper threshold
0x08 (8) Startup Startup delay currently
Delay running
0xFF (255) Deactivated Feature is deactivated
Tab. 5-12: Speed Monitoring State
Speed Monitoring Value
With Speed Monitoring Value, the current speed value can
be read.
5.3.5 System Commands
Command Device Action
Value
0x81 (129) Application Reset – Resets writable
parameters to the default value.
0x82 (130) Reset Factory Settings – Resets writable
parameters to the default value.
0xAA (170) Signal Speed Monitoring Reset – Resets
the speed value and flags.
Tab. 5-13: Speed Monitoring State – System Commands
For an overview of all System Commands, see section 3.5
on page 21.
www.balluff.com english 43