Balluff BES M12EH1-L01C40B-S04G-L04 Anleitung Seite 128

BES M12EH1-L01C40B-S04G-L04 / BES M18EH1-L01C80B-S04G-L04
Inductive sensors
4
Primary Device Functions (continued)
Transducer Signal
See Transducer Signal on page 31.
4.3.6 System Commands
Command Value Device Action
0x40 (64) Teach Apply – Calculates the
switching point for SP1, SP2.
0x41 (65) Teach SP1 (ADSS: Teach SP) –
Determines teach point 1 for
setpoint 1 and calculates the
switching point.
0x42 (66) Teach SP2 – Determines teach
point 1 for setpoint 2 and calculates
the switching point
0x43 (67) Teach SP1 TP1 (ADSS: Teach TP1)
– Determines teach point 1 for
setpoint 1
0x44 (68) Teach SP1 TP2 (ADSS: Teach TP2)
– Determines teach point 2 for
setpoint 1
0x45 (69) Teach SP2 TP1 – Determines teach
point 1 for setpoint 2
0x46 (70) Teach SP2 TP2 – Determines teach
point 2 for setpoint 2
0x47 (71) Teach SP1 Start (ADSS: Teach SP
Start) – Starts dynamic teach-in for
setpoint 1
0x48 (72) Teach SP1 Stop (ADSS: Teach SP
Stop) – Stops dynamic teach-in for
setpoint 1 and calculates the
switching point.
0x49 (73) Teach SP2 Start – Starts dynamic
teach-in for setpoint 2
0x4A (74) Teach SP2 Stop – Stops dynamic
teach-in for setpoint 2 and
calculates the switching point
0x4E (78) Teach Reset – Any active teach-in
process is interrupted, all
temporarily stored values are reset.
0x4F (79) Teach Cancel – Any active teach-in
process is interrupted.
Tab. 4-16: Switching profiles – System Commands
For an overview of all System Commands, see section 3.5
on page 21.
34 english
4.3.7 Events
Event Event Description
Code Type
0x8DC0 Notifica- Teach-in timeout – The
(36288) tion current teach process
took too long and was
interrupted.
Tab. 4-17: Basic statistics – Events
Device
Status
0 – Device
is
operating
properly.