Instructions For Use; Before Initial Operation; Regulating The Speed - WOLFF Rührwerk Power X 1000 Originalbetriebsanleitung

Instructions for use

WARNING!
Before performing any work on the mixer,
pull out the mains plug.
CAUTION!
The mains voltage and the voltage
specification on the rating plate must match.

Before initial operation

Unpack the mixer and check that there are
no missing or damaged parts.
Mounting/changing the mixer paddle
Tool without spindle lock:
Bolt the paddle onto the drive
spindle (1.).
Counterhold the drive spindle with an open-
end spanner AF 19 and tighten the mixer
paddle with an open-end spanner.
Remove in the reverse order.
Tool with spindle lock:
Press the lock and turn the gear selector switch
in anti-clockwise direction to
(1.).
Bolt the paddle onto the drive spindle
(2.).
Tighten the mixer paddle with an open- end
spanner AF 22 (3.).
Remove in the reverse order.
Gear selection
(POWER X 1600)
CAUTION!
Only select gear with motor stationary.
Press lock (1.) and turn switch in anti-
clockwise direction to the required
stage (2.)
POWER X 1600
I
Output stage with higher torque
II Output stage with higher speed
Spindle lock for changing mixer
Paddle

Regulating the speed

(POWER X 1000)
To adjust the maximum working speed,
set the speed preselector switch to the
desired stage.
Speed
Stage
1
2
3
15
I II
210 320
325 490
530 780