Noise And Vibration - WOLFF Rührwerk Power X 1000 Originalbetriebsanleitung

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A-weighted noise level of the power tool is
typically:
Emission value a
Power X 1000
Power X 1600
Uncertainty K = 1.5 m/s
Vibration total value (when mixing mineral
materials of medium viscosity):
WARNING!
The indicated measurements refer to new
power tools. Daily use causes the noise and
Sound
pressure L
[dB(A)]
79
Power X 1000
79
Power X 1600
Uncertainty K = 3 dB
vibration values to change.
2
[m/s ]
h
< 2.5
< 2.5
2
Sound power
pA
L [dB(A)]
WA
90
90
NOTE!
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given
in EN 60745 and may be used to compare
one tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary
to take into account the times when the tool
is switched off or running but not actually in
use. This may significantly decrease the
exposure level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and
the accessories, keep the hands warm,
organisation of work patterns
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).
14
.