Restriction Of Use; Maintenance; Use - WOLFF 013463 Betriebsanleitung

3.3 Restriction of use

The Triac Set is designed for welding PVC-, Polyolefine-,
Caoutchouc and Linoleum floor coverings in dry rooms. Any
other or comprehensive usage is not according the defined
application.
Wolff is not liable for any damage or loss caused by this.
3.4 Genuine Spare Parts
Spare parts and accessories are designed especially for the
Triac Set.
We explicitly point out that other parts must not be used. By
using other parts the safety of the device can be jeopardized.
Wolff is not liable for damage caused by not using genuine spare
parts.

4.0 Maintenance

The Triac Set is nearly maintenance-free.
The hot air nozzle should be cleaned from floor covering
residues from time to time. The welding tool's airfilter (5) should
be cleaned with a brush if necessary.
The carbon brushes will wear down to about 6mm (this may take
several years) after which the power will disconnect automatically.
Have the tool checked by your service centre.
Changing the heating element
Allow the tool to cool down, or use only combination pliers.
Do not touch hot parts and put them on a heat resistant
surface, because of fire hazard!
remove the screws (1) of the tapered element housing (2)
and remove housing
remove the sealing ring of the heating element and change
the heating element
put on tapered element housing and tighten the screws (1)

5.0 Use

The Triac Set is designed for welding PVC-, Polyolefine-,
Caoutchouc and Linoleum floor coverings.
The various materials need different welding temperatures.
Thermoplasts like PVC or Polyolefines can be welded with
maximum temperature.
For welding Linoleum or caoutchouc materials, pay attention to
the manufacturer's specifications.
Heat only the area of the groove. The other parts besides the
groove should not be heated. You avoid shiny stripes along the
groove by that means.
03/2011 Triac Set #013463
The defined application also includes
to take care of all directions from the operating
manual and
the execution of maintenance and service.
(2) (1)
Disconnect power supply before changing the heating
element!
9