Overload Protection; Maintenance And Care - WOLFF Rührwerk Power X 1000 Originalbetriebsanleitung

Switching the mixer on and off Brief
operation without engaged switch rocker
First press the starting lockout (1.). Then
press and hold down the switch (2.).
Release switch interlock (3.).
To switch off, release the switch (4.).
Continuous operation with engaged
switch rocker
 First press and hold down the starting
lockout (1.) and then the switch (2.).
 To lock into position, further press the locking
button and release the switch (3.). Release
switch interlock (4.).
To switch off, briefly press and release the
switch (5.)..
NOTE!
If the mixer does not turn after switching on:
– Switch the power tool off (release lock by
pressing switch).
– Rotate the mixer paddle manually by 45°.
– Switch the power tool back on again.
Operating instructions
 After it has been switched off, the mixer
runs on for a short time.
 If the rotating mixer paddle strikes a
surface, it could cause a jolt.
 Only switch on the tool after the mixer
paddle has been immersed in the product
to be mixed. When doing this, slowly
press the switch and wait until the tool
has reached maximum speed.
 When taking a break from work, place
the tool down on the rests

Overload protection

In the event of a short and extreme overload,
the overload protection device prevents
damage to the motor by switching the tool off
automatically. For further information on the
manufacturer's products go to
www.wolff-tools.com.

Maintenance and care

WARNING!
Before performing any work on the mixer,
pull out the mains plug.
Cleaning
 Regularly clean the power tool and
ventilation slots.
 Regularly blow out the housing interior
and motor with dry compressed air.
 Clean the mixer paddle straight after
use. Do not allow the mixed product to
dry on.
16