Safety Instructions; Electrical Connection - Electrolux ERCP3215AW Benutzerhandbuch

4 www.electrolux.com
•
•
•

2. SAFETY INSTRUCTIONS

2.1 Installation
• Remove all the packaging.
• Do not install or use a damaged
• Obey the installation instruction
• Always be careful when you move the
• Make sure the air can circulate around
• Wait at least 4 hours before connecting
• Do not install the appliance close to
• The rear of the appliance must stand
• Do not install the appliance where
• Do not install this appliance in areas
• When you move the appliance, lift it by

2.2 Electrical connection

• The appliance must be earthed.
Downloaded from www.Manualslib.com
Clean the appliance with a moist soft cloth. Only use
neutral detergents. Do not use abrasive products,
abrasive cleaning pads, solvents or metal objects.
Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or
similarly qualified persons in order to avoid a hazard.
WARNING!
Only a qualified person must
install this appliance.
appliance.
supplied with the appliance.
appliance because it is heavy. Always
wear safety gloves.
the appliance.
the appliance to the power supply. This
is to allow the oil to flow back in the
compressor.
radiators or cookers, oven or hobs.
against the wall.
there is direct sunlight.
that are too humid or too colds, such
as the construction appendices,
garages or wine cellars.
the front edge to avoid scratching the
floor.
WARNING!
Risk of fire and electrical
shock.
manuals search engine
• Make sure that the electrical
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
electrical components (e.g. mains plug,
mains cable, compressor). Contact the
Authorised Service Centre or an
electrician to change the electrical
components.
• The mains cable must stay below the
level of the mains plug.
• Connect the mains plug to the mains
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.
2.3 Use
WARNING!
Risk of injury, burns, electrical
shock or fire.
• Do not change the specification of this
appliance.
• Do not put electrical appliances (e.g.
ice cream makers) in the appliance
unless they are stated applicable by
the manufacturer.
• Be careful not to cause damage to the
refrigerant circuit. It contains isobutane
(R600a), a natural gas with a high level