Electrolux ERCP3215AW Benutzerhandbuch Seite 12

12 www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the Shopping
Function, or after changing
the temperature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The ActionFreeze or
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Downloaded from www.Manualslib.com manuals search engine
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The Shopping Function
function is switched on.
This is normal, no error
has occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Shopping Function func-
tion is switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Solution
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "Shopping Function
function".
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off ActionFreeze or
Shopping Function manually,
or wait until the function re-
sets automatically to set the
temperature. Refer to "Ac-
tionFreeze or Shopping Func-
tion function".
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.