Blower Operation; Cleaning The Machine - Makita DUB185 Betriebsanleitung

Number
3
2
1
NOTICE:
When turning the dial, be sure to com-
pletely release the switch trigger. Otherwise, the
machine may be damaged.
OPERATION
CAUTION:
Do not place the machine on the
ground while it is switched on. Sand or dust may
enter from suction inlet and cause a malfunction or
personal injury.

Blower operation

CAUTION:
When performing the blower oper-
ation, be sure to remove the dust bag from the
machine, and attach the nozzle in place for blowing.
Hold the machine firmly with a hand and perform the
blowing operation by moving it around slowly. When blow-
ing around building, big stone or vehicle, direct the nozzle
away from them. When performing an operation in a
corner, start from the corner and then move to wide area.
For DUB185
► Fig.10
For DUB186
► Fig.11
Vacuuming operation
CAUTION:
When performing the vacuuming
operation, be sure to attach the dust bag and
nozzle in place to the machine.
CAUTION:
Check the dust bag frequently for
wear or deterioration.
CAUTION:
Be sure to fasten the fastener of
the dust bag before operating the machine.
CAUTION:
Always switch off the machine
before opening or fastening the fastener of the
dust bag.
NOTICE:
When performing the vacuuming oper-
ation, do not use the garden nozzle. The materials
sucked may be clogged, and cause a malfunction of
the machine.
NOTICE:
Do not allow wet materials, such as
wet leaves, and foreign materials, such as large
wood chips, metals, glass, pebbles, etc., to be
sucked into the machine. Otherwise, a malfunction
may occur.
NOTICE:
Empty the dust bag before it becomes
full. Otherwise, a malfunction may occur.
Hold the machine with both hands. While operating the
Speed
machine, adjust the switch trigger so that the suction
High
force is appropriate for the work location and conditions.
► Fig.12
Medium
Low
Empty the dust bag before it becomes too full by remov-
ing the dust bag from the machine, and then removing
the fastener.
► Fig.13: 1. Fastener
MAINTENANCE
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

Cleaning the machine

Clean the machine by wiping off dust with a dry cloth or
one dipped in soapy water and wrung out.
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
Remove dust or dirt from the suction inlets.
► Fig.14: 1. Suction inlet
11 ENGLISH
CAUTION:
Always be sure that the machine is
Never use gasoline, benzine, thinner,