ASROCK H61M-HVGS Schnellinstallationsanleitung Seite 18

Surround Display Feature
This motherboard supports surround display upgrade. With the internal VGA output
support (HDMI and D-Sub) and external add-on PCI Express VGA cards, you can
easily enjoy the benefits of surround display feature.
Please refer to the following steps to set up a surround display environment:
1. Install the PCI Express VGA card on PCIE1 slot. Please refer to page 16 for
2. Connect HDMI monitor cable to HDMI port on the I/O panel, and connect
3. Boot your system. Press <F2> or <Del> to enter UEFI setup. Enter "Onboard
4. Install the onboard VGA driver and the add-on PCI Express VGA card driver to
5. Set up a multi-monitor display.
18
Downloaded from www.Manualslib.com
proper expansion card installation procedures for details.
D-Sub monitor cable to D-Sub port on the I/O panel. Then connect other
monitor cables to the corresponding connectors of the add-on PCI Express VGA
card on PCIE1 slot.
VGA Share Memory" option to adjust the memory capability to [32MB], [64MB],
[128MB], [256MB] or [512MB] to enable the function of D-sub. Please make
sure that the value you select is less than the total capability of the system
memory. If you do not adjust the UEFI setup, the default value of "Onboard VGA
Share Memory", [Auto], will disable D-Sub function when the add-on VGA card is
inserted to this motherboard.
your system. If you have installed the drivers already, there is no need to install
them again.
®
For Windows XP / XP 64-bit OS:
Right click the desktop, choose "Properties", and select the "Settings" tab
so that you can adjust the parameters of the multi-monitor according to
the steps below.
A. Click the "Identify" button to display a large number on each monitor.
B. Right-click the display icon in the Display Properties dialog that you
wish to be your primary monitor, and then select "Primary". When
you use multiple monitors with your card, one monitor will always be
Primary, and all additional monitors will be designated as Secondary.
C. Select the display icon identified by the number 2.
D. Click "Extend my Windows desktop onto this monitor".
E. Right-click the display icon and select "Attached", if necessary.
F. Set the "Screen Resolution" and "Color Quality" as appropriate for the
second monitor. Click "Apply" or "OK" to apply these new values.
G. Repeat steps C through E for the diaplay icon identified by the number
one, two, three and four.
ASRock H61M-HVGS / H61M-HVS Motherboard
manuals search engine