Step 3: Connect Your Oscilloscope; Inputs And Outputs - PICO PicoScope Kurzanleitung

Quick Start Guide

Step 3: Connect your oscilloscope

1. If your oscilloscope is mains-powered, connect the power cord to the power adaptor and
plug it into a mains power socket. Then connect the DC power cord to the back of the
oscilloscope and switch on the mains power.
2. Connect the oscilloscope to your PC using the USB cable supplied. See the connection
diagram below for more information.
a
PicoScope PC oscilloscope
b Oscilloscope USB port
d
c
Pico USB cable
e
c
3. Wait for your computer to install the oscilloscope. While doing so it will display a message
or icon in the taskbar telling you it has found the device.
4. Run the software.
5. If you wish to use a probe, connect one to Channel A. Touching the metal tip of the probe
should cause a small 50 or 60 hertz signal to appear in the PicoScope window.
DO115-21
d PC
e
PC USB port
f Power adaptor
a
f
b
Copyright © 2006–2021 Pico Technology Ltd. All rights reserved.
3.1

Inputs and outputs

1
Note: PicoScope 5000D Series 4-channel models are shown here. Other models may have a
different arrangement of connectors. Refer to your oscilloscope's data sheet for details.
Oscilloscope analog inputs. Refer to maximum input voltage marked on front
1
panel of oscilloscope. [BNC(f) or SMA(f)]
Probe compensation pin. Refer to the documentation supplied with your
probe for compensation instructions. For oscilloscopes without a probe
2
compensation pin, the built-in signal generator may be used to provide a signal
for probe compensation.
MSO logic inputs. Refer to maximum input voltage marked on front panel of
3 oscilloscope. Refer to User's Guide for pinout if not using the supplied cable.
[20-way header]
Ext External trigger input. [BNC(f)]
PicoScope USB Oscilloscopes
2 3
Continued overleaf
5