Setting Up Your Multi-Touch Chassis Display; System Requirements; Unpacking Your Touch Display - 3M Multi-Touch C3266PW Bedienungsanleitung

279
Chapter 1

System Requirements

Unpacking Your Touch Display

Downloaded from www.Manualslib.com

Setting Up Your Multi-Touch Chassis Display

To setup your display unit:
•
Unpack the components
•
Connect the video cable, touch display cables, and power cable
•
Power on the display and test your setup
•
If your operating system does not support native touch, install the MT7 software on
the enclosed CD.
This display requires a personal computer (PC).
•
Your PC must have an available USB port or RS-232 serial communication port
(C3266PW only). Connect the touch sensor cable to the communication port.
•
Your PC must have a pre-installed video card and video driver for the display.
Note: Before setting up your Multi-Touch Chassis Display, please refer to the
"Important Safety Information" section at the beginning of this document.
Carefully unpack the carton and inspect the contents. Your Multi-Touch Chassis Display
includes the following:
USB Cable
VGA Cable
3M Touch Systems, Inc. Proprietary Information
manuals search engine
3M™ Multi-Touch Chassis Display User Guide
9-pin RS-232 serial cable
(Qty 2 for C3266PW only)
DVI Cable