Setting Up Your 3M Multi-Touch Chassis Display; System Requirements; Unpacking Your Touch Display - 3M Multi-Touch C3266PW Bedienungsanleitung

6
Chapter 1
Setting Up Your 3M Multi-Touch Chassis
Display
To setup your display you need to complete the following tasks:





System Requirements

This display requires a personal computer (PC).


Note: Before setting up your 3M Multi-Touch Chassis Display, refer to the
"Important Safety Information" section at the beginning of this document.

Unpacking Your Touch Display

Carefully unpack the carton and inspect the contents. Your 3M Multi-Touch Chassis
Display includes the following:
Unpack the components
Connect the video cable, touch display cables, and power cable
Power on the display and test your setup
If your operating system does not support native touch, install 3M
MicroTouch™ MT7 Software.
Your PC must have an available USB port or RS-232 serial communication
port (C3266PW only). Connect the touch sensor cable to the communications
port.
Your PC must have a video card and video driver already installed for the
display.
USB Cable
VGA Cable
3M Touch Systems, Inc. Proprietary Information
TM
3M Multi-Touch Chassis Display User Guide
9-pin RS-232 serial cable
(Qty 2 for C3266PW only)
DVI Cable