Important Notes - 3M Multi-Touch C3266PW Bedienungsanleitung

276

Important Notes

Downloaded from www.Manualslib.com
Intended Use
The 3M™ Touch Systems Touch Displays are designed for touch input and tested to
replace an existing display. These displays are intended for professional installation and
use in an indoor environment. They are not designed or tested for use in hazardous
locations. Use in any other application has not been evaluated by 3M and may create
unsafe conditions.
•
In extreme temperature and humidity situations, you may observe condensation
between the sensor and the display. To minimise this condition, place the unit where
it will be used and allow a 24-hour environmental stabilisation period prior to
powering on the display. Any noticeable condensation is temporary and will have no
long-term effect on the operation of the display.
•
Please be warned that any change or modification to the equipment, not expressly
approved by the party responsible for compliance, could void your warranty.
•
When unplugging the power supply cord, hold the plug, do not pull by the cord.
•
Do not connect or disconnect this product during a thunder storm or lightning.
•
Remember to take into account that the operating temperature of the installation may
be greater than room ambient temperature, and consideration should be given to
installing the unit in an environment compatible with the maximum rated operating
temperature. Specifications can be found in the product data sheet on the 3M Touch
Systems website at http://www.3m.com/touch/.
•
The 3M Multi-Touch Chassis Display may not function as expected at altitudes
above 2000 meters.
•
3M Touch Systems recommends vacuuming or replacing the fan filter at least every
six months or if a noticeable increase in surface temperature occurs.
•
When installing the unit, ensure that it does not restrict the flow of air to any other
equipment within the installation required for safe operation.
•
An inherent characteristic of the PCT sensor is a fine grid pattern that may be visible
under certain lighting conditions.
•
Install the display in a well-ventilated area. Always maintain adequate ventilation to
protect the display from overheating and to ensure reliable and continued operation.
•
Do not expose this display to direct sunlight or heat. Passive heat may cause damage
to the housing and other parts.
•
Do not install this display in areas where extreme vibrations may be generated. For
example, nearby manufacturing equipment may produce strong vibrations. The
vibrations may cause the display to exhibit picture discoloration or poor video
quality.
•
The 3M touch controllers mentioned in this document are USB compatible full speed
devices.
3M Touch Systems, Inc. Proprietary Information
manuals search engine
3M™ Multi-Touch Chassis Display User Guide