Service And Repair Indicators; Touch Sensor Care And Cleaning - 3M Multi-Touch C3266PW Bedienungsanleitung

5

Service and Repair Indicators

Touch Sensor Care and Cleaning

Downloaded from www.Manualslib.com
•
3M does not warrant that we are USB compliant pursuant to USB specifications.
•
Cooling fan will cycle based on internal temperature. When the internal temperature
grows higher than ambient, the fan will turn on.
•
System will shut down when internal temperature reached a critical level
Do not attempt to service this unit yourself. Unplug the display and refer to an authorized
service personnel in the event that:
•
The product is exposed to liquid.
•
The product does not operate properly when the operating instructions are followed.
•
The product exhibits a distinct change in performance, indicating a need for service.
•
The power cable or plug is damaged or frayed
Filter Replacement Procedure
3M Touch Systems recommends to vacuum or replace the fan filter at least every six
months or if a noticeable rise in surface temperature occurs.
•
Remove screws from the filter cover
•
Remove filter cover and filter
•
Replace filter (Use 3M filter # 98-1100-0230-4)
•
Re-install cover
Periodically clean the glass touch sensor surface. Turn off your display before cleaning.
An isopropyl alcohol and water solution ratio of 50:50 is the best cleaning agent for your
touch sensor.
•
Apply the cleaner with a soft, lint-free cloth. Avoid using gritty cloths.
•
Dampen the cloth and then clean the sensor. Spray the cleaner onto the cloth, not
the sensor, so that drips do not seep inside the display or stain the bezel.
3M Touch Systems, Inc. Proprietary Information
manuals search engine
3M™ Multi-Touch Chassis Display User Guide