Indications, Functions And Options; Home Screen - Caleffi 161010 Installationsanleitung Für Denqualifizierten Techniker

Factory Area
setting
TMax 50 °C 30 °C ... 90 °C Maximum temperature of the heating
Remote regu- No Yes, No
lation
Cooling No Yes, No
TCool 16 °C 5 °C ... 25 °C Cooling temperature
TMin No Yes, No
TMin 10 °C 5 °C ... 20 °C Minimum cooling temperature
RH% control Yes Yes, No
Chiller option No Yes, No
VMin 0,0 V 0,0 ... 9,9 V
VMax 10,0 V 0,1 ... 10,0 V Maximum control signal
Increment 0,1V 0,1 ... 1,0 V
tPlay 0,2 V 0,0 ... 1,0 V
Feedback No Yes, No
Block. prot. Yes Yes, No
PWM Heating Heating, Solar PWM A Curve
Slab drying - -
TStart 20 °C 10 °C ... 30 °C Slab drying start temperature
TMax 45 °C 20 °C ... 60 °C Slab drying hold temperature
Rise 5 K 1 ... 10 K
Rise time 24 hours 1 ... 24 h
tBacking 7 days 1 ... 20 d
Start - Start, Cancel Slab drying activation/deactivation
Language Italiano Deutsch, Eng-
lish, Français,
Italiano,
Español, Por-
tuguês, 中文
Reset No Yes, No
Operation 0 0 ... 9999
14
Meaning
circuit
Remote control option
Cooling option
Minimum temperature option
Dew point detector option (TPS)
Cooling request option on
Minimum control signal
Control signal increment/decrement
Control signal increment/decrement
for a direction change
Feedback signal option
Anti-seizing option
Slab drying submenu
Slab drying rise value
Slab drying rise time
Slab drying hold time
Language selection
Reset to factory settings
Operating days of the controller (bal-
ance, the value cannot be reset)
Factory Area
setting
Pump - 0 ... 9999
Backup heat. - 0 ... 9999
S1 value - max. 999,9
°C
S2 value - max. 999,9
°C
S3 value - max. 999,9
°C
Version - -
All relays Auto Auto, Off
Man 1 Auto On, Auto, Off
Man 2.3 Auto Mixer Close,
Auto, Mixer
Open, Off
Man 4 Auto On, Auto, Off
Back
5

Indications, functions and options

Note
The displayed channels, parameters and setting ranges depend on
the chosen system, the selected functions and options, and the com-
ponents connected to the system.

5.1 Home screen

The home screen is a graphical representation of the current system status.
The following settings are available:
Standby
The room thermostat does not request heating nor cooling.
Meaning
Statistics, these values cannot be
reset (see page 20)
Software version display
Select operating mode of all relays
Relay 1 in manual mode
Relay 2.3 in manual mode
Relay 4 in manual mode