Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BUBBLE LAND
IMPORTANT: RETAIN FOR FU-
TURE REFERENCE - READ CARE-
FULLY.
WARNING: BEFORE USE, RE-
MOVE AND DISPOSE OF ALL
PLASTIC BAGS AND PACKAG-
ING MATERIALS AND KEEP
THEM OUT OF REACH OF CHIL-
DREN.
INTRODUCTION
BUBBLE LAND is a practical and functional chang-
ing table with baby bath, designed to nestle the
baby during diaper changing and bath time.
Components
A - Frame
A1 - Shelf
A2 - Screws (x2)
A3 - Changing table
A4 - Feet (x4)
A5 - Joints
A6 - Changing table fastening clamp
A7 - Button for changing table fastening clamp
A8 - Tub fastening block
B - Tub
B1 - Rubber plug
B2 - Drainage pipe
B3 - Drainage pipe terminal
B4 – Cushioned pad
WARNINGS FOR CHANGING MAT
• This changing unit is intended
for use with child from birth to 12
months, up to 11 kg. For home
use only.
• WARNING: Do not leave the child
unattended.
• WARNING: Take into account risk
of free flames and other sources of
strong heat such as electric stoves,
gas stoves, etc. in the immediate
vicinity of the product.
• Never use the product without
tub mounted on the frame.
• Do not use the product if any part
is broken, torn or missing.
• Do not use accessories, spare parts,
or any component not supplied or
approved by the manufacturer.
• This product must only be used by
an adult.
• To avoid the risk of injury, make
sure that the space above the
product is suitable (there should
be no shelves, furniture, etc..).
• Do not place more than one child
at a time in the changing table.
• Do not place the product on sur-
faces that are not perfectly flat.
• All securing devices for assembly
must be tightened correctly and
checked regularly.
• Do not allow other children to play
unsupervised near the product.
• Do not overload the bottom shelf
with weights exceeding 5 kg.
• When unused, the product should
be kept out of reach of children.
• Check the stability of the assem-
bled product before use.
• WARNING: Always remove the
drainage hose and keep it out of
the reach of children.
• Use the hose only to drain water.
• Always check that the tub is fixed
to the support and is stable.
ASSEMBLY
The boxed product is already partially assem-
bled and the following instructions must be fol-
lowed in order to complete assembly:
1. Position the frame (A) upright, grasp the two
upper tubes and push them in the opposite
direction to open the product (Fig. 1).
2. After opening frame (A), fasten the joints (A5)
so that they are locked (Fig. 2).
3. Now install the 4 feet (A4) (Fig. 3).
WARNING: To ensure that the product is stable,
10
Werbung
