Extension Shaft - hanseatic BHE 3020 Gebrauchsanweisung

• Hold the file guide bar) and file according to the angles
marked on horizontally (at right angle to side of the
file holder. Rest the file holder on the top plate and
depth gauge.
• Always file from the inside to the outside of the cutter.
• The file only sharpens on the forward stroke – lift the
file off the cutter on the backstroke.
• Avoid touching the tie straps and drive links with the
file.
• Rotate the file at regular intervals while filing to avoid
one-sided wear.
• Use a piece of hardwood to remove burrs from cut-
ting edge.
All cutters must be the same length. If the cutters are not
the same length, they will have different heights. This
makes the chain run roughly and increases the risk of
breakage of the chain.
Downloaded from www.Manualslib.com manuals search engine
4. 706 MM EXTENSION SHAFT
To reach a high position, you can add an extension shaft
between the main body and add-on attachment.
When use hedge trimmer or chain saw to cut high
branches,the falling twigs and saw dust may hurt youe
face and hands. Always wear helmets with visor and pro-
tective gloves to prevent damage to your view and skin.
Tight fitting clothingand safety boots should also be worn
to prevent injury.
GB-17