Mounting The Tool; Mounting The Bar And Chain - hanseatic BHE 3020 Gebrauchsanweisung

Flush-cutting thick branches
• If branch diameter is more than 4" (10 cm), first per-
form undercut ( 3) and then cross-cut at a distance (A)
of about 8" (20cm) from the final cut.
Then carry out the flush-cut (4), starting with a reliev-
ing cut and finishing with a cross-cut.
Cutting above obstacles
The unit's long reach makes it possible to prune branches
that are overhanging obstacles, such as rivers or lakes.
The tool angle in this case depends on the position of
the branch.

Mounting the Tool

Loosen wing screw (1) on the coulping sleeve (2), and
pull the knob (3) and Insert the driver tube (4) until
the lock button secured in place.Screw down the wing
screw(1).
3
2
Downloaded from www.Manualslib.com
1
manuals search engine

Mounting the Bar and Chain:

1 Unscrew nut and take off the sporcket cover.
2 Turn tensioning screw (1) anticlockwise until the ten-
sioning nut (2) butts against the left.
The chain is very sharp – wear work gloves to pro-
tect hands from cuts.
3 Fit the chain – start at the bar nose.
4 Fit guide bar over the stud (3). Engage peg of ten-
4 sioner slide in locating hole (4) – place the chain over
sprocket (5) at the same time.
GB-13