Starting / Stopping The Engine; Operating Instructions - hanseatic BHE 3020 Gebrauchsanweisung

Always thoroughly shake the mixture in the canister be-
fore fueling your machine.
In order to reduce the risk of burns or other per-
sonal injury from escaping gas vapor and fumes,
remove the fuel filler cap carefully so as to allow
any pressure build-up in the tank to release slowly.
After fueling, tighten fuel cap as securely as pos-
sible by hand.

Starting / Stopping the Engine

Starting
1 Put the stop switch in the position '1''1'
2 Slide the choke to position 'start'. This is not required
in case of a warm start.
3 Push the fuel pump 6 times.
4 Push the starter rope 2-3 times, to start the motorit is
required to evenly, quickly pull the rope.
5 Slide the chock to RUN positon, slightly push the throt-
Downloaded from www.Manualslib.com manuals search engine
tle trigger and pull the starter rope again until the mo-
tor starts running. To push the throttle trigger(1) it is
necessary to first push the locking lever(2).
2
6 Let the motor idle for about 10 seconds to warm up.
7 If the motor does not start please repeat the upward-
steps.
Stopping
1 Release the throttle trigger. Let the engine idle. push-
the ignition switch to position "stop". The engine will-
now stop.

Operating Instructions

During break-in period
A factory new machine should not be run at high revs (full
throttle off load) for the first three tank fillings. This avoids
unnecessary high loads during the break-in period. As all
moving parts have to bed in during the break-in period,
the frictional resistances in the engine are greater during
this period. power after about 5 to 15 tank fillings.
During operation
After a long period of full-throttle operation, allow engine
to run for a while at idle speed so that the heat in the en-
gine can be dissipated by flow of cooling air. This protects
engine-mounted components (ignition, carbur-etor) from
thermal overload.
After finishing work
Wait for engine to cool down. Drain the fuel tank. Store
themachine in a dry place. Check tightness of nuts and
screws (not adjusting screws) at regular intervals and
retighten as necessary.
GB-10
1