Product Design; Using Your Camera; Setting Menu - Rollei Skibrille 135 Full-HD Anleitung

Product design

Main parts of the camera
Camera
1. Photo button
2. On/off/recording button
3. SD card slot
4. USB slot
5. Reset
6 . L E D I n d i c a t o r – T h e L E D
indicator is assembled into the
inside of the goggles. You can see
the LED in the right top corner.

Using your camera

1. To start recording
A) Wear the camera goggle and focus on what you would like to record.
B) Short press on/off button to power on the camera, when the green LED
indicators are on and there is a short vibration, it means the camera is in
standby mode.
C) Press the power ON/OFF button again, there is a vibration alert and blue LED
light flash every second, it means the camera is recording.
D) If the camera in standby mode, press the recording button to start recording.
E) To switch the camera off, press the power button for about three seconds.
The goggles will vibrate longer and the LED and the camera will switch off.
2. To take a picture
A)Press on/off button, the camera will go into standby mode when we hear a
short vibrate and the green LED light are on.
B)Short press the photo button for capturing a picture, when the blue LED light
flash one time,it means the photos have been taken successfully.
3. PC Camera
When connect the camera with the PC, Long press the photo button, removable
disk disappears, the camera is in PC CAM mode.
4. RESET
When the camera will not operate correctly, please press reset button for 1
second, the system will return to off status, repress the on/off button for normal
operation.

Setting menu

1. EV
Higher EV can increase the brightness of the video quality.
2. Light Frequency
To avoid the flicker for indoor use, the right frequency needs to be set.
3. Time stamp
Set time stamp, then the exact time will display on the video and photo.
4. Resolution
Change the resolution between 1080p and 720p.
Setting.txt
1. Connect the camera to the PC with USB cable
2. Find the setting.txt by opening the removable disk