Product Overview; Insert The Battery - Rollei Gimbal Bedienungsanleitung

1. Product overview

Rolling 360° Tilting 360°
Panning
360°
Battery
cover
Part of the delivery
• 1x rechargeable battery
• 1x micro USB cable
• 2x screws (mounted on actioncam holder)
• 1x clip (mounted on actioncam holder)
• 1x transport bag
• 1x user manual
2. Installation
Download and install the Rollei app "AC Gimbal" onto your smartphone.
The Rollei app supports iOS 8.0 and Android 4.4 or above.

3. Insert the battery

The battery needs to be fully charged before the device is used for the first
time. The charging time is about 2.5 hours when it is directly charged by
a power outlet (therefore an adapter is needed which is not part of the
delivery). If the gimbal will be charged the indicator light will flash. If the
battery is fully loaded, the indicator light will constantly shine.
The battery needs to be inserted into the handle of the gimbal. Therefore,
please unscrew the lowest part of the handle. Then insert the battery into
the handle (the minus polarity shows in the direction of the small part of
the handle). Afterwards the small part can be screwed onto the handle
again.
ENGLISH
Tilting axis
Rolling axis
Panning axis
Indication light
5­way joystick
USB port
Multifunction
button
1/4 inch
screw hole
Charging: Insert the USB cable into the USB port of the
gimbal and plug the other side into a charging port of
a power source
4. Insert the Actioncam
You don't need an additional counter weight. This product is perfectly
compatible with Gopro* Hero* 5 and Hero* 4 / 3 or other actioncams of
similar size and weight.
If the device is turned off, the gimbal can reach the best self­balance status
by setting the right position of the motors and the camera.
1
2
Two Different Ways of Installation
Fig. 1 GoPro* Hero* 5 (The lens is next to the pitch motor)
Put the pitch motor to the RIGHT side. Place the GoPro* Hero* 5 closely to
the back clip as shown in the picture and tighten the screws to secure the
actioncam firmly.
Fig. 2 GoPro* Hero* 3 / 4 or other actioncams of similar size and weight.
(The lens is opposite to the pitch motor.)
Insert the Gopro* Hero* 4 / 3 etc. closely to the clip as shown in the picture
and tighten the screws.
5. Power On
Turn the gimbal on by pressing the function button so
long until the indicator light flashes twice.
5