Basic Operation; Adjusting The Volume - Kenwood NX-3200E Einfache Anleitung

SWITCHING POWER ON/ OFF
Key type:
Press [ ] to switch the transceiver ON.
Press [ ] again to switch the transceiver OFF.
Knob type:
Turn the [Power switch/ Volume control] clockwise to switch the transceiver ON.
Turn the [Power switch/ Volume control] counterclockwise fully to switch the transceiver OFF.

ADJUSTING THE VOLUME

Key type:
Press the key programmed as [Volume Up] to increase the volume. Press the key programmed as [Volume Down] to
decrease the volume.
Knob type:
Rotate the [Power switch/ Volume control] to adjust the volume. Clockwise increases the volume and counterclockwise
decreases it.
SELECTING THE ZONE AND CHANNEL
Select the desired zone and channel using the keys programmed as [Zone Up]/ [Zone Down] and [Channel Up]/
[Channel Down].
TRANSMITTING
1 Select the desired zone and channel.
2 Press the key programmed as [Monitor] or [Squelch Off] to check whether or not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the PTT switch and speak into the microphone. Release the PTT switch to receive.
• For best sound quality at the receiving station, hold the microphone approximately 3 cm to 4 cm (1.5 inches) from your mouth.
RECEIVING
Select the desired zone and channel. If signaling has been programmed on the selected channel, you will hear a call only if
the received signal matches your transceiver settings.

BASIC OPERATION

3
< PO_BASIC_OP_PMR >