Controls And Functions; Repeater Operation - Kenwood NXR-710 Bedienungsanleitung

CONTROLS AND FUNCTIONS

■ Front Panel
q Speaker
w CH/STATUS Display
Two 7-segment digits display the channel number, name,
or status.
e VOLUME control
Rotate to adjust the audio.
r POWER switch
t POWER indicator
Lights green when power is supplied to the DC 13.2V
jack.
■ Rear Panel
TEST/SPKR
q TX OUT jack
Connect a TX antenna or a duplexer to this receptacle.
w CONTROL I/O jack
Connect a repeater controller or a remote panel to this
DB-25 interface.
e REF IN jack
Connect to a 10 MHz external oscillator.
r RX IN jack
Connect an RX antenna or a duplexer to this BNC
receptacle.

REPEATER OPERATION

Note: Please consult your dealer for programming the repeater.
When power is applied to the unit, the POWER indicator lights:
・ Green when using the DC jack.
Rotate the VOLUME control to adjust the audio.
The BUSY indicator lights green while receiving a signal and the
TX indicator lights red while transmitting.
q w
TX OUT
CONTROL
I / O
i
q
y MIC jack
Connect a microphone to this 8-pin modular jack.
u Programmable Function keys
Press these keys to activate their programmable
functions.
i BUSY indicator
Lights green while a signal is being received.
o TX indicator
Lights red while transmitting.
e r t
REF IN RX IN
FUSE 15A
DC 13.2V
N S Y N C
u y
t FUSE
Insert 15 A blade fuse into this fuse holder.
y DC 13.2V jack
Connect a 13.2 V DC power supply to this jack.
u N SYNC 1 / 2 jack
This jack is currently not used. Future functions include
connecting another repeater or optional device.
i TEST/SPKR jack
Test input/output jack. Connect an external speaker to
this jack.
TRANSCEIVER OPERATION
■ Receive
Adjust the volume to your desired level. You may need to
readjust the volume if you are having interference while
receiving a message from your dispatcher or another member
in your fleet.
The BUSY indicator lights green while a signal is being
received.
■ Transmit
1 Listen to the channel before transmitting, to make sure it
is not being used.
2 Press the microphone PTT switch, then speak in your
normal speaking voice.
The TX indicator lights red while transmitting.
3 When you finish speaking, release the PTT switch.

w e r
t
CH/STATUS
VOLUME
POWER
BUSY
TX
MIC
o i u y