Kenwood NX-3200E Einfache Anleitung Seite 3

INFORMATION CONCERNING THE BATTERY PACK
The battery pack includes fl ammable objects such as organic solvent. Mishandling may cause the battery to rupture producing fl ames or
extreme heat, deteriorate, or cause other forms of damage to the battery. Please observe the following prohibitive matters.
DANGER
◆ Do not disassemble or reconstruct battery.
◆ Do not short-circuit the battery.
◆ Do not incinerate or apply heat to the battery.
◆ Do not leave the battery near fi res, stoves, or other heat generators (areas reaching over 80°C).
◆ Do not immerse the battery in water or get it wet by other means.
◆ Do not charge the battery near fi res or under direct sunlight.
◆ Use only the specifi ed charger and observe charging requirements.
◆ Do not pierce the battery with any object, strike it with an instrument, or step on it.
◆ Do not jar or throw the battery.
◆ Do not use the battery pack if it is damaged in any way.
◆ Do not solder directly onto the battery.
◆ Do not reverse the battery polarity (and terminals).
◆ Do not reverse-charge or reverse-connect the battery.
◆ Do not touch a ruptured and leaking battery. If the electrolyte liquid from the battery gets into your eyes, wash your eyes out with
fresh water as soon as possible, without rubbing your eyes. Go to the hospital immediately. If left untreated, it may cause eye-
problems.
WARNING
◆ Do not charge the battery for longer than the specifi ed time.
◆ Do not place the battery pack into a microwave or high pressure container.
◆ Keep ruptured and leaking battery packs away from fi re.
◆ Do not use an abnormal battery.
SAR VALUES FOR PMR446 TRANSCEIVER
Model
TK-3701D-E
TK-3601D-E
TK-3501-E
PKT-23-E
RF EXPOSURE LIMITS FOR PMR446 TRANSCEIVER
ATTENTION:
Before using this PMR446 transceiver, read this simple guide.
This PMR446 transceiver uses radio frequency (RF) electromagnetic energy to allow communication between two or more users over a
distance.
It uses radio frequency (RF) energy or radio waves to send and receive calls.
KENWOOD PMR446 transceiver is designed, manufactured and tested to meet Council Recommendation 1999/519/EC RF exposure
limits, and exposure limits provide recommended exposure levels to the general public.
To keep RF exposure within acceptable limits, do not transmit for more than 50% of the transceiver total usage time.
Transmitting over 50% of the total use time may exceed the limits in accordance to the FCC RF exposure requirements.
To ensure compliance, hold the transceiver in a vertical position in front of your face, with the microphone and other parts of the
transceiver including the antenna at least 2.5 cm away from the nose or lips.
Longer distance between your face and the antenna reduces RF exposure.
SAR face
0.63 W/kg
0.47 W/kg
0.37 W/kg
0.42 W/kg
2
SAR trunk
0.95 W/kg
1.36 W/kg
0.54 W/kg
0.67 W/kg
< PO_NOTICE >