Basic Operations; Switching Power On/Off; Adjusting The Volume - Kenwood NX-220 Bedienungsanleitung

SWITCHING POWER ON/OFF

Turn the Power switch/ Volume control clockwise to switch the
transceiver ON.
Turn the Power switch/ Volume control counterclockwise fully
to switch the transceiver OFF.
■ Transceiver Password (Types I and II Only)
If your transceiver is password protected, you must first
enter the password before you can use the transceiver.
1 Rotate the Selector to select the first digit of the
password.
2 Press the S
the next digit.
• Press the A or # key to delete an incorrect digit.
3 Repeat steps 1 and 2 to enter the entire password.
• The password can contain a maximum of 6 digits.
4 Press the S
• If you enter an incorrect password, an error tone sounds
and the transceiver remains locked.

ADJUSTING THE VOLUME

Rotate the Power switch/ Volume control to adjust the volume.
Clockwise increases the volume and counterclockwise
decreases it.
SELECTING A ZONE AND CHANNEL/GROUP ID
Select the desired zone using the key programmed as [Zone
Select] or [Zone Up/Down]. Each zone contains a group of
channels.
Select the desired channel/group ID using the Selector knob
(default). Each channel/group ID is programmed with settings
for transmitting and receiving.
12

BASIC OPERATIONS

key to accept the entry and move to
or
key to confirm the entered password.
or