SATA AE1023H Bedienungsanleitung Seite 66

Fault phenomenon
Motor inability
Out-of-operation of motor
Unfastened hexagon rod lock
Large clearance of sliding
arm
Cylinder gas blow-by
Cylinder air leakage
Five-way valve air leakage
Five-way valve gas blow-by
Oil atomizer air leakage
No oil drop from oil atomizer
Air leakage from rotary
distribution valve
Gas blow-by from rotary
distribution valve
Failure in closing opened
claw/jittering
The belt is liable to damage
The positive and negative
rotation of switch is opposite.
Loud noise produced by
reduction gearbox
66
AE1023H/AE1023H-3
Fault causes
Damage of 220 V motor starting capacitor
Phase loss of 380 V power source
Loose belt
Damage of 220 V motor starting capacitor
Phase loss of 380 V power source
Damage to switch or wiring error
No power source or poor plug contact
Large clearance of locking plate
Wrong position of upper and lower roller bearing and
side top thread
Damage of piston seal ring/gas pipe joint
O-ring damage/piston rod scratch/gas pipe joint
damage
O-ring damage/gas pipe joint damage
O-ring damage
O-ring damage/foreign matters/gas pipe joint damage
Too little amount of oil drop adjusted/no oil
O-ring damage/gas pipe joint damage
O-ring damage
Foreign matters/no lubricating oil/claw deformation
Too tight belt/out-of-level between the belt pulley and
the belt disk/overuse
Wrong wiring
Loose screw/no lubricating oil/bearing damage
中文
EN DE RU KO
Troubleshooting methods
Replace the capacitor
Check phase of power source
Tighten the belt
Replace the capacitor
Check phase of power source
Check switch wiring/replace the switch
Check power source/replace plug
Adjust the clearance of locking plate
Adjust position
Replace
Replace
Replace
Replace
Replacement/removal of foreign matters
Increase the amount of oil drop/refueling
Replace
Replace
Clean up foreign matters/lubricate/
replace
Adjust position and level/replace
Reconnect/replace
Lock screw/lubricate/replace
PT JA ES