Attaching The Wrist Cuff; Fastening The Wrist Cuff; How To Take Proper Measurements; How To Measure Blood Pressure - Wellion WWAVE032 Handbuch

ATTACHING THE WRIST CUFF

Fastening the wrist cuff

1. Wrap the wrist cuff around your wrist about 1-2 cm below your hand as shown in the figure below.
2. Fasten the wrist cuff tightly by using the hook-and-loop strip. For proper measurements, fasten the wrist cuff
tightly and measure on a bare wrist.

How to take proper measurements

For best accuracy in blood pressure measurement:
Sit comfortably at a table. Rest your wrist on the table.
Relax for about 5 to 10 minutes before making a measurement.
Raise your hand so that the wrist cuff is at the same level as your heart.
Remain still and keep quiet during measurement.
Do not measure right after physical exercise or a bath.
Measure your blood pressure at about the same time every day.

HOW TO MEASURE BLOOD PRESSURE

1. Fasten the wrist cuff according to the instructions in "ATTACHING THE WRIST
CUFF".
2. Press the "ON/OFF" button; all icons automatically appear two seconds on
the display, then the device switches to measurement and displays "00".
3. When the measurement starts, the cuff in the strap will automatically
inflate. The inflating icon will flash on the display. When the
measurement is completed, the results will be displayed.

Read Memory

Press the "MEM" button to scroll through the memorized results, starting with the latest measurement. Press "MEM" to go up, and "SET" to go down
in the list of results.
EN
25