Scsi Id And Terminator Settings; Scsi Id Settings - Canon DR-3060 Installationshandbuch

SCSI ID and Terminator Settings

Use the DIP switches on the rear of the scanner to make the SCSI ID and
terminator settings.
For the DIP switches, the upper position is the ON position, and the lower
position is the OFF position.
Factor settings
(Terminator: OFF; SCSI ID = 2)
ON
1 2 3 4
SCSI ID switches
Terminator ON/OFF switch

SCSI ID Settings

Refer to the following table when setting the SCSI ID. If there are other SCSI
devices connected to or inside the PC, make sure to set a unique ID for the
scanner.
SCSI ID SW2
0
1
2
3
4
5
6
7
Notice
When the scanner is shipped from the factory, the SCSI ID is set to "2."
Although any value from 0 to 7 is valid as a SCSI ID, "7" is normally reserved
for the SCSI host adapter, and should therefore not be used. In addition, "0"
and "1" are normally used by internal SCSI hard disks that are used for system
startup, so do not use these IDs either.
16
Installing the Scanner
SW3
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
SW4
OFF
ON
OFF
ON
OFF
ON
OFF
ON