Unit Installation Sh/Shr Units - Toshiba RAV-104NH-PE Installationsanleitung

Unit Installation – SH/SHR Units
Before Installation
(1)
Side
panel
(left)
(2)
Remove
the hanger
(left, right).
GB
(5)
Pull the air filter out then remove the inlet grille fixing
screws.
Detailed figure of
the hinge portion
Hinge
In case of removing the inlet
grille take the hinge portion off
in order of 1 - 2 .
Recommended Mounting Height
G
It is recommended that the unit is mounted
150mm above the floor.
150mm or more
Tel: 01823 665660
Downloaded from www.Manualslib.com
Heronhill - for all your Toshiba requirements
Take off the accessories.
Inlet grille
Body
(3)
Remove all the
metal shipping fix-
tures (left, corner,
10-20mm
centre, right corner).
(4)
Remove the side
panels by hand. Slide
them in order of
1 - 2 .
Shipping fixture
(centre)
Body
manuals search engine
I U L
NDOOR NIT OCATION
Installing Ø 10 Wall Bolts
Ø Wall Bolts are procured locally
G
Install wall bolts at the spacings shown below.
G
Securely fix left
and right side
panels with a
screw supplied
after unit
installation.
Side panel
(right)
Amm
Model
164SH/SHR
264SH/SHR
G
The positions of the hanging bolts are printed on the
carton box (the size is not printed).
Position of hanging bolt
Bmm (inner hanging)
Installing Hexagon Bolts (accessory)
Determining installation position and direction
of the piping and wiring
Knock out
Gas line connection
Liquid line
connection
Knock out
attachment)
Drain connection
(OD 20mm)
Opening knock out hole
In case of right or left attachment
~ 18 ~ ~ 18 ~
www.heronhill.co.uk
INNER HANGING
Hole for expanded bolt
(4 – 12 x 27 slots)
Wall bolt pitch
Bmm (Wall bolt pitch)
Amm
A B
1030 920
1230 1120
indicates the
(ø 10 printed)
rear end of the
detached on
the dotted line.
BOTTOM VIEW
Knock out
(right or left
attachment)
(rear
SIDE VIEW
Cut the slit portion
by a saw or knife
Slit
Fax: 01823 665807
G
The
dotted line
unit. To be
Allow a
spacing of
about
10mm