IGM LAGUNA PFlux 3 Gebrauchsanweisung Seite 9

Step Eighteen: Secure the base of the foot pedal bar to the triangular support
Step 18: Secure the base of the foot pedal bar to the triangular support
plate by holding the lower support plate vertically up against the foot pedal bar
plate by holding the lower support plate vertically up against the foot pedal
and securing the U channel provided onto the foot pedal bar using (2)5/16"*1-3/4"
Step Eighteen: Secure the base of the foot pedal bar to the triangular support
bar and securing the U channel provided onto the foot pedal bar using
hex bolts, (4) 5/16"*OD18*2t flat washers and (2) 5/16" hex nuts
plate by holding the lower support plate vertically up against the foot pedal bar
(2)5/16"*1-3/4" hex bolts, (4) 5/16"*OD18*2t flat washers and (2) 5/16" hex
out. Follow the same steps for the opposite side.
and securing the U channel provided onto the foot pedal bar using (2)5/16"*1-3/4"
nuts from the inside out. Follow the same steps for the opposite side.
hex bolts, (4) 5/16"*OD18*2t flat washers and (2) 5/16" hex nuts
out. Follow the same steps for the opposite side.
Step Nineteen: Attach the cover plate over the foot peddle assembly. Secure
using (6) 1/4"*3/4" hex bolts and (6) 1/4"*OD19*2t flat washers.
Step Nineteen: Attach the cover plate over the foot peddle assembly. Secure
same steps for the opposite side.
Step 19: Attach the cover plate over the foot peddle assembly. Secure
using (6) 1/4"*3/4" hex bolts and (6) 1/4"*OD19*2t flat washers.
using (6) 1/4"*3/4" hex bolts and (6) 1/4"*OD19*2t flat washers. Follow the
same steps for the opposite side.
same steps for the opposite side.
3HP Mobile Dust Cyclone Manual
3HP Mobile Dust Cyclone Manual
Step 20: Attach the two ends of the Octagon foot pedal to the nut on the
foot pedal bar.
www.igmtools.com
Pic. 21
from the inside
from the inside
U Channel
U Channel
U Channel
Hex bolt head
Hex bolt head on
on inner side
inner side
Hex bolt head on
Pic. 22
inner side
Follow the
Follow the
Pic. 23
Step 21: Secure the topping to the nut on the foot peddle bar. Follow
this step on the opposite side.
Step 22: Secure the topping with (2) M8*30mm hex bolts.
23
Step 23: Align the bolt hole on the movable supporting brace on the
foot peddle bar with the bolt hole on the octagon foot peddle.
23
-9-
Pic. 24
Pic. 25
Pic. 26