IGM LAGUNA PFlux 3 Gebrauchsanweisung Seite 12

Step 37: Attach the rubber gasket to the top inner edges of the
Octagon drum. The wider end of the gasket goes up. You will need tin
snips to trim any excess rubber gasket after completing the seal.
Rubber gasket
Step 38: Place the vacuum suction ring inside before inserting the
plastic bag in the Octagon drum.
Step Thirty Eight: Place the vacuum suction ring inside before inserting the
plastic bag in the Octagon drum.
Vacuum suction ring
Vacuum suction ring
Step Thirty Nine: Insert the plastic bag inside the Octagon drum. Open and
spread out the plastic bag to the corners and edges
Step 39: Insert the plastic bag inside the Octagon drum. Open and
spread out the plastic bag to the corners and edges.
www.igmtools.com
3HP Mobile Dust Cyclone Manual
Pic. 40
Pic. 41
Pic. 42
Step Forty: Lift the foot peddle bar. Align the Octagon drum window to the center
Step 40: Lift the foot peddle bar. Align the Octagon drum window to the
Step Forty: Lift the foot peddle bar. Align the Octagon drum window to the center
point of the drum lid and push the drum in. Lower the foot peddle bar to seal
center point of the drum lid and push the drum in. Lower the foot peddle
point of the drum lid and push the drum in. Lower the foot peddle bar to seal
the drum tight for normal machine operation.
bar to seal the drum tight for normal machine operation.
the drum tight for normal machine operation.
1
1
Step Forty One: Make sure when aligning the drum that both the left and right
Step Forty One: Make sure when aligning the drum that both the left and right
side lift plates are over the topping on the foot peddle bar assembly before lifting
Step 41: Make sure when aligning the drum that both the left and right
side lift plates are over the topping on the foot peddle bar assembly before lifting
the foot peddle bar up. When not aligned, the drum will not be fully sealed and
side lift plates are over the topping on the foot peddle bar assembly before
the foot peddle bar up. When not aligned, the drum will not be fully sealed and
will interfere with the air flow.
lifting the foot peddle bar up. When not aligned, the drum will not be fully
will interfere with the air flow.
sealed and will interfere with the air flow.
Step 42: Remove the control panel by loosening the six bolts holding it to
the panel. Secure the two handles to the control panel using (4) M4*6mm
philip hd bolts.
-12-
Pic. 43
2
2
Pic. 44
3HP Mobile Dust Cyclone Manual
Pic. 45
3HP Mobile Dust Cyclone Manual
3
3
34
3