IGM LAGUNA PFlux 3 Gebrauchsanweisung Seite 7

Step 5: Attach the intake cylinder to the dust chute using (4) 5/16"*5/8" hex
spring bolts. Then, attach the cyclone barrel onto the dust chute using (12)
5/16"*3/4" hex bolts and (12) 5/16"*OD18*2t flat washers followed by
attaching the cyclone funnel to the barrel using (12) 5/16"*3/4" hex bolts,
(24) 5/16"*OD18*2t flat washers and (12) 5/16" hex nuts.
Step Six: Take the vacuum suction tube for the cyclone barrel. This can be
Step 6: Take the vacuum suction tube for the cyclone barrel. This can be
located in the top Styrofoam packaging. Attach foam tape around the inner edges
located in the top Styrofoam packaging. Attach foam tape around the
of the plate facing the longer side of the tube as shown below. Make sure to
inner edges of the plate facing the longer side of the tube as shown below.
attach the foam tape on the inner edges below the bolt holes. Attach the vacuum
Make sure to attach the foam tape on the inner edges below the bolt
suction tube with the end top pointing upwards to the dust chute using the four
holes. Attach the vacuum suction tube with the end top pointing upwards
bolts provided.
to the dust chute using the four bolts provided.
Foam tape on inner side
Foam tape on inner side
facing longer side of tube
facing longer side of tube
Step Seven: Secure the base with (3) lower upright support panels to the
unit using (6) 5/16"*3/4" hex bolts and (6) 5/16"*OD18*2t flat washers.
Step 7: Secure the base with (3) lower upright support panels to the
unit using (6) 5/16"*3/4" hex bolts and (6) 5/16"*OD18*2t flat washers.
www.igmtools.com
Pic. 8
Pic. 9
Vacuum tube pointing up
Vacuum tube pointing up
inside the cyclone barrel.
inside the cyclone barrel.
Pic. 10
Step 8: Secure the (3) upright support reinforcement plates using (12)
5/16"*3/4" hex bolts and (12) 5/16"*OD18*2t flat washers.
Step 9: With the help of another person, lift the unit up carefully to the
right side up with the motor on top and the wheels at the bottom.
Step 10: Secure the side canister filter shield (I) in place using (4)
1/4"*3/4" hex bolts and (4) 1/4"*OD19*2t flat washers.
-7-
Pic. 11
Pic. 12
Pic. 13
Pic. 14