IGM LAGUNA PFlux 3 Gebrauchsanweisung Seite 11

Step 30: Take the Octagon drum side panels and assemble together, secure
with (40) M4*12mm sheet metal thread bolts. Take note of the left and right
panels; do not assemble the incorrect sides. Refer to the next step.
Step 31: The panels have labels R and L on them to show you which
panels should be bolted together to prevent any confusion. Please
assemble them together per photo below.
Step Thirty Two: Both the left and right side lift panels have three bolt holes on
Step 32: Both the left and right side lift panels have three bolt holes on
them. Take the matching side plate and secure to the outside of the panel.
them. Take the matching side plate and secure to the outside of the panel.
(Photo shown is the inside of the panel) using (6) 1/4"*1/2" carriage bolts, (6)
(Photo shown is the inside of the panel) using (6) 1/4"*1/2" carriage bolts,
1/4"*OD19*2t flat washers and (6) 1/4" hex nuts.
(6) 1/4"*OD19*2t flat washers and (6) 1/4" hex nuts.
View of side panels
View of side panels
from inside out.
from inside out.
Pic. 36
www.igmtools.com
Step Thirty Three: Take the Octagon base panel with wheels and secure on to
the bottom of the drum using M4*12mm sheet metal thread bolts
Pic. 33
Pic. 34
Pic. 35
Step 33: Take the Octagon base panel with wheels and secure on to
the bottom of the drum using M4*12mm sheet metal thread bolts.
Step Twenty Four: Secure the movable supporting brace on the foot pedal bar
with the octagon foot pedal
head is on the inside of the octagon foot pedal. Adjust the tightness of this bolt
Step 34: Take the plastic bolt end caps to cover all the bolt ends on the
accordingly. If this bolt is too tight, the Octagon foot peddle will not work
inside of the Octagon drum using (40) plastic end caps. This step is
smoothly. When too loose it will not pick up the Octagon drum.
necessary to prevent any injuries caused by the sharp end of the bolts.
Step Twenty Five: Apply foam tape to the cone flange before attaching the drum
lid. Secure the Octagon drum lid to the cyclone funnel using (8) 5/16"*3/4" hex
bolts, (16) 5/16"*OD18*2t flat washers and (8) 5/16" hex nuts. Make sure to first
attach all the bolts on before tightening the bolts.
have not been tightened for alignment.
Step 35: Once completing the assembly, apply silicone to the inside of
being able to align with the drum. the drum including the base to seal and prevent air leakages.
Silicone
3HP Mobile Dust Cyclone Manual
Step 36: Attach the handles to the top and bottom end on the front panel
with the window display using (4) flat head Philip bolt, (4) 5/16"*OD23*2t
flat washers and (4) 5/16" hex nuts.
-11-
Pic. 37
using (2) 3/8"*21mm hex bolts. Make sure the bolt
Pic. 38
The lid will turn when the bolts
Failure to do will result in the drum lid not
You will find a tag on the cone with
the following warning. Take note
and remove tag when you have
completed this step.
Caution, before tightening the
screws, make sure that the
lid is aligned with the center
of the hood.
Pic. 39
2