Electrical Installation; Servicing - Bromic Heating PLATINUM SMART-HEAT Installations-, Anweisung- Und Wartungsanleitung

ELECTRICAL INSTALLATION

WARNING
!
This heater MUST be permanently installed by
an authorised/licenced person. Do not perform
maintenance, or carry out installation or assembly
procedure while electrical power is switched on.
! WARNING
ELECTRICAL SHOCK HAZARD! Serious injury or death
may occur. Disconnect from electrical supply before
installing or servicing this heater. Read and follow
installation clearance requirements outlined in this
manual. The appliance MUST be connected to a properly
grounded electrical source.

SERVICING

! WARNING
ELECTRICAL SHOCK HAZARD!
Serious injury or death may occur.
Disconnect from electrical supply before servicing this
heater.
!
WARNING
Servicing and maitenance MUST be carried out by an
authorised and licenced service person only.
WARNING
!
If the supply cord is damaged, it must be replaced by
Bromic, a service agent of Bromic or similarly qualified
persons in order to avoid a hazard. Contact Bromic for
further information on replacement of the supply cord.
14
Downloaded from www.Manualslib.com manuals search engine
ELECTRICAL INSTALLATION
1. Check product label for correct voltage and wattage
- Make sure power source conforms to the heaters
requirements.
2. Use appropriate power supply cables for the heaters'
voltage and wattage with minimum temperature rating
of 105°C. The fixed wiring must be positioned away
from & protected from the enclosure of the heater.
3. Make all connections in accordance with local
electrical code regulations. For outdoor installation all
connections must be made in accordance with local
electrical code regulations for outdoor wiring. Only
use wiring components approved for outdoor use with
minimum IPX5 rating.
MAINTENANCE
For longest product life & to maintain product appearance
mount heater under cover & protect from rain & weather
whenever possible.
The exterior housing of the heater should be cleaned
regularly. To clean the appliance, ensure heater is off and
has been off for at least 2 hours after operation, and wipe
off any dirt/dust with a soft damp cloth.
For locations near the coast, salt in the air can cause rusting
of metal. Additional cleaning of the heater with a soft
damp cloth fortnightly will increase the life of the products
appearance.
www.bromicheating.com