Leckey Squiggles Early Handbuch Seite 9

Dynamic trunk support
cushion attachment
To attach the cushion first remove the
dynamic trunk assembly from the seat base
and lay it down flat. Open the side fasteners
and hooky panels of the trunk support.
Insert one end of the assembly into the
pocket in the cushion. Then sleeve the other
end of the inner into the opposite end of the
cushion. Once in position snap the fasteners
together around the plastic rods and the one
fastener in the middle of the support plate.
Finally secure the Velcro tabs at the back.
You can then reattach the trunk support as
detailed in Section 7.
Leg support cushion
and positioning
strap attachment
The leg support cushion and pommel is
secured by Velcro, simply position the
cushion in the recess and push down
firmly to locate in position.
The positioning strap is attached by looping
the strap underneath the plastic base and
securing the Velcro panel to the base.