Fitting The Cushions / Components - Leckey Squiggles Early Handbuch

Fitting the
cushions
Seat cushion attachment
To attach the seat cushion place the seat
shell onto a flat work surface. Drape the
side panels over the shell and then align the
hooky with the receiving fluffy on the seat
base. Secure the two top front fasteners
first, then turn upside down and secure the
two fasteners underneath the seat shell. Line
up all remaining external fasteners to secure
the cover in place.
Once the cover is secured feed the two
female buckles through the slits at either
side to allow attachment of the four point
pelvic harness. Ensure the buckles are
protected by the cushion at all times to
prevent irritation to the user.
Always ensure the side flaps conceal
the adjustments and metalwork away
from children.
Four point pelvic
harness attachment
The Pelvic Harness contains four attachment
points, two at the front (A) and two at the
back (B). Clip the two front buckles into their
receivers on either side of the seat base.
Then attach the remaining two rear buckles
into their receivers at the rear of the seat
base.
A
B