Leckey Squiggles Early Handbuch Seite 11

Dynamic trunk support
angle adjustment
The trunk support can be secured in an
upright sitting position, or locked in any
angle, retaining flexibility. It can be adjusted
while the user is in the seat. To angle adjust,
open the flap at either side and loosen
the plastic knobs, set the supports to the
desired position and then retighten securely.
Use the markers on the labels as a guide to
ensure both sides are set to the same angle
Dynamic trunk support
width adjustment
To width adjust the trunk support open the
flap at the front and pull the tensioning strap
to the desired position. The flap is attached
with Velcro® and can be repositioned so it is
centrally aligned around the child.
Close the flap and secure with the two snap
fasteners at the front.
If the child has a feeding tube ensure
the trunk support does not restrict or
interfere with it.
Prone bar
This position can be used to promote
development of the spinal curves, stability of
the trunk and improved function. The seat
base with the leg support attached can be
elevated into prone by inserting the prone
bar into the underside of the seat base.
To attach the prone bar, turn the seat base
upside down, press the poppers in and slide
the prone bar into the receiving tubes at the
back of the seat. The bar is secure when the
poppers engage in the holes in the receiving
tubes. To remove reverse the process.
Place the seat with prone bar attached on a
stable flat surface.
Set the trunk support angle to 115 degrees
so the child is in an upright position. Fine
tuning of the trunk support can be carried
out with the child in the seat.
Check that the product is stable and
never leave the child unattended
especially if they are very active
in the seat.