Leckey Squiggles Early Handbuch Seite 6

Attaching the leg
support to the seat
The leg support is supplied complete
with support cushion, leg abduction
pommel and a positioning strap.
To attach the leg support assembly insert
the inner tubes into the receiving sleeves
on the seat base assembly and secure
at the sides with the locking knobs. The
maximum extension is indicated by two
holes on the inner tubes, when these are
visible the leg support assembly is in it's
maximum extension.
Prone bar attachment
If you have ordered the prone bar, remove
it from its packaging. This component
should only be used with the seat
assembled together with the Leg Support.
To attach the prone bar, turn the seat base
upside down, press the poppers in and
slide the prone bar into the receiving tubes
at the back of the seat. The bar is secure
when the poppers are engaged in the holes
in the receiving tubes. To remove reverse
the process.
When the part is not in use store it in a
safe place out of reach to children.
Tray assembly
If you have ordered a Tray it will come
packaged disassembled for transport.
To assemble insert the tubes into the
outer sleeve until the popper engages.
Secure with plastic knob. Repeat for the
other leg, ensuring both legs are set to
the same height.
Spacer Pads
To attach the spacer pads first remove
the dynamic trunk support from the
seat assembly and lay it down flat on
a work surface.
Wrap the spacer pad/s around the cushion
ensuring that the top fastens down over
the bottom between the flexi rods and
secure with the snap fasteners. Reattach
the dynamic trunk support to the seat base
as detailed above under "Dynamic trunk
support attachment"