Cleaning & Care Information; Daily Product Inspection; Annual Product Inspection - Leckey Squiggles Early Handbuch

11 Cleaning & Care
Information
How to Maintain
When cleaning we recommend that you
use only warm water and a non-abrasive
detergent. Never use organic solvents or dry
cleaning fluids.
Upholstery and Fabrics
Cleaning the Fabric
(Manufacturer guidelines)
The most effective way to clean the fabric is
by using warm water and a detergent, such
as Fairy Liquid following the simple steps
shown below.
1. Soak a cloth eg a J cloth in warm water and
wring out the excess liquid. (For body fluids eg.
blood, urine, use cold water).
2. Apply a small amount of detergent
onto the cloth.
3. Clean the fabric paying particular attention
to badly stained areas.
4. Apply the cloth to the fabric using
a firm circular motion.
5. A nylon nailbrush can be used on
more stubborn stains. This fabric is extremely
durable and brushing it will not cause any
damage.
6. Rinse off the surface of the fabric with warm
water ensuring all soap residue
is removed. This fabric is totally
waterproof. Water will not penetrate
the surface of the fabric and get through
to the foam filling. However, care should be
taken where there are stitch lines as liquid may
seep through.
7. The fabric can then be either left to dry
naturally or any excess surface moisture can
be mopped up using paper towels.
8. Once the fabric has dried it is advisable to
lightly brush the surface using a soft brush.
9. More stubborn stains can be removed using
mineral spirit or isopropyl alcohol providing the
area being cleaned off is washed with soap
and water immediately afterwards. A half cup
of household bleach to 5 litres of water can
also be used as a useful disinfectant.
10. Chlorine based cleaning agents such as
CHLOR-CLEAN or HAZ-TABS can be used
to disinfect the product providing they do not
contain more than 10% chlorine by volume.
11. When using a proprietary product it
is important to follow the directions on
the container.
12. Never use organic solvents such as
dry cleaning fluids.
13. Always ensure the product is dry
before use.
As an alternative to the steps outlined above,
alcohol wipes can be used as an effective
means of cleaning to prevent cross infection.
Following independent testing excellent
stain removal has been found for -
Simulated Vomit (Porridge), Simulated Vomit
(Pureed Carrot), Orange Juice, Gravy, Toast/
Butter/Marmite, Tomato Sauce, Salad Cream/
Mayonnaise, Lipstick, Nail Varnish, Ball Point
Pen Marks, Soy Sauce, Fruit Juice, Animal
Blood, Urine, Iodine, Betadine, Suntan Lotion,
Grease.
Antifungal/Antimicrobial Properties
The upholstery used on the positional
components has an antifungal and
antimicrobial treatment which helps to prevent
and contain cross-infection. This treatment
is permanent and cannot be washed out. If
you clean your product using the methods
described the risk of cross-infection will be
greatly reduced.
Metal and Plastic Components
1. Soap and water or antibacterial spray can
be used for daily cleaning.
2. For deep cleaning a low pressure steam
cleaner can be used.
3. Do not use solvents eg Cellulose Thinners to
clean plastic or metal components.
4. Make sure the product is dry before use.
12 Daily Product
Inspection
(Therapists, parents & carers)
We recommend that daily visual checks of the
equipment are carried out by therapists, carers
or parents to ensure the product is safe for
use. The recommended daily checks
are detailed below.
1. Ensure all adjustment knobs and bolts are in
place and secure.
2. Check all upholstery and Velcro® for signs
of wear and tear.
3. Ensure the pelvic harness is fully secured
around the user and they cannot slide or creep
forward in the seat.
If in any doubt to the continued safe use of
your Leckey product or if any parts should fail,
please cease using the product and contact
our customer care team or your local dealer as
soon as possible.
13 Annual Product
Inspection
(Therapist, Technician, VIDA Product
Specialist, Dealer)
Leckey recommend that each product should
be subject to a detailed inspection at least
once a year and every time the product is
reissued for use. This inspection should be
carried out by a technically competent person
who has been trained in the use of the product
and should include the following checks as a
minimum requirement.
1. Check all knobs, nuts, bolts and plastic
buckles are in place, replacing any missing
items. Paying particular attention to the
following items;
- Trunk Support height and angle
adjustments bolts.
- Pelvic harness attachment points.
- Chair attachment straps.
2. Check that there is no visible wear or tear
on the metal or plastic components.
3. Visually check the structure of the product
paying attention to weld points on the frame
ensuring there are no signs of fatigue or
cracking around the welds.
4. Leckey recommend that a written record is
maintained of all annual product inspections.
If in any doubt to the continued safe use of
your Leckey product or if any parts should fail,
please cease using the product and contact
our customer care team or your local dealer as
soon as possible.