Husqvarna ROYAL 53SE Betriebsanleitung Seite 10

Starting & Stopping Royal 53S, 53S Intek.
Starting
1. Connect the spark plug
lead.
2. Move the Engine
Speed Control to the
FAST '+' position
before starting. (J1)
3. Pull the operator
presence control (OPC)
to release the brake on
the engine and the
blade.(J2)
4. Pull the recoil starter
fully towards you until
you feel the full
resistance, return the
handle slowly then pull
the handle firmly
towards you to its full
extent. (J3)
5. After the engine has
started, allow to run for
30 seconds before
commencing to use.
Engaging the Drive
1. Forward drive is
engaged and
disengaged with the
Powerdrive lever at the
top of the handle (J4).
2. Drive speed can be
altered with the drive
speed control. (J5)
3. Releasing the
Powerdrive Lever stops
the forward drive
automatically.
Stopping
1. Release the
powerdrive lever.
2. Release the OPC
lever.
English - 5
Downloaded from www.Manualslib.com
USE - STARTING AND STOPPING
J1
J2
J3
recoil starter
J4
J5
drive speed
control
engine speed
control
manuals search engine
Starting & Stopping Royal 53SE
Starting
1. Follow steps 1-3 for the
Royal 53S
2. Turn the key and hold
-
until the engine starts
(K1). The key will
return to the original
position when
released.
+
3. If the engine fails to
start when you turn the
key your battery may need charging.
Please note:- Your Royal 53SE can be started
manually by following steps 1-5 in
Starting & Stopping Royal 53S, 53S Intek
Key Start Only - During mowing, your engine
will recharge the battery
Engaging the Drive - See Royal 53S, 53S Intek
Stopping - See Royal 53S, 53S Intek
K1