Operation - Makita BTD129 Bedienungsanleitung

For tool with shallow bit hole
A=12mm Use only these type of bit. Follow the
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For tool with deep bit hole
A=17mm
B=14mm
A=12mm
B=9mm
011405
Procedure (1)
Fig.7
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
Procedure (2)
In addition to the procedure(1) above, insert the bit-piece
into the sleeve with its pointed end facing in.
Fig.8
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
Hook
Fig.9
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Downloaded from www.Manualslib.com
To install these types of bits, follow
the procedure (1).
To install these types of bits, follow
the procedure (2).
(Note) Bit-piece is necessary for
installing the bit.
manuals search engine

OPERATION

Fig.10
CAUTION:
Do not cover vents, or it may cause overheating
•
and damage to the tool.
Fig.11
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
Standard bolt
N m
(kgf cm)
120
(1224)
100
(1020)
80
(816)
M12
60
(612)
M10
40
(408)
M8
20
(204)
0 1.0 2.0 3.0
Fastening time (S)
006255
High tensile bolt
N m
(kgf cm)
120
M12
(1224)
100
(1020)
80
(816)
60
(612)
M8
40
(408)
20
(204)
0 1.0 2.0
Fastening time (S)
006257
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
6
M14
(M14)
(M12)
(M10)
(M8)
(M12)
M10
(M10)
(M8)
3.0