Hints And Tips; Care And Cleaning; Cleaning The Filter - Electrolux TE1120HP Benutzerhandbuch

40 www.electrolux.com

9. HINTS AND TIPS

9.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which are
specified in the programs chapter.
• Clean the filter after each drying cycle.
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use distilled water like that used for
steam ironing. If it is necessary, clean
the distilled water before (e.g. with a
coffee filter) to remove any particles.
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
9.2 Adjustment of the remaining
laundry moisture degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold down
the
dry buttons.
One of the symbols goes into the view on
the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the
again and again until you set
necessary degree.

10. CARE AND CLEANING

10.1 Cleaning the filter

At the end of each cycle the
symbol comes on the display and you
must clean the filter.
The filter collects the lint
during the drying cycle.
Half load and Cupboard
Start/Pause button
6. To memorise the setting, push at the
same time the
Cupboard dry buttons for
approximately 2 seconds.
9.3 Deactivating the Reservoir
indicator
The water container indicator is by default
on. It starts to light at the end of the drying
cycle or during the cycle if the water
reservoir is full. If the draining kit is installed
the water container is drained
automatically and indicator can be
permanently off.
To deactivate the indicator:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold down
the
buttons.
One of 2 configurations is possible:
• the Reservoir indicator:
• the Reservoir indicator:
Filter
Half load and
Half load and
and the symbol
the view - the water container
indicator is permanently on
and the symbol
the view - the water container
indicator is permanently off
To achieve the best drying
performances clean the filter
regularly , clogged filter lead
to longer cycles and energy
consumption increase.
Use your hand to clean the
filter , and if necessary , a
vacuum cleaner .
Iron dry
is on
goes into
is off
goes into