Care & Maintenance; Check Filter Indicator; Cleaning The Filter - Levoit Vista 200-RXW Bedienungsanleitung

EN
C A R E & M A I N T E N A N C E
Cleaning the Air Purifier
• Unplug before cleaning.
• Wipe the outside of the air purifier with
a soft, dry cloth. If necessary, wipe
the housing with a damp cloth, then
immediately dry.
• Vacuum the inside of the air purifier.
• Do not clean with abrasive chemicals or
flammable cleaning agents.
When Should I Replace the
Filter?
The filter should be replaced every 6–8
months. You may need to replace your filter
sooner or later depending on how often you
use your air purifier. Using your air purifier in
an environment with relatively high pollution
may mean you will need to replace the filter
more often, even if
You may need to replace your filter if you
notice:
• Increased noise when the air purifier
is on
• Decreased airflow
• Unusual odours
• A visibly clogged filter
Note: To maintain the performance of your air
purifier, only use official Levoit filters. To buy
replacement filters, visit Levoit's online store.
Go to levoit.com for more information.
•
If your home has high air pollution, you
may need to change your filter before
lights up.
•
Remember to reset
the filter.
10
is off.
after changing

Check Filter Indicator

will light up as a reminder to check the
filter. Depending on how much you use the
air purifier, the indicator should turn on within
6–8 months. You may not need to replace
your filter yet, but you should check it when
turns on.

Cleaning the Filter

The True HEPA Filter should be cleaned
once a month to increase the efficiency and
extend the life of your filter. Clean the inside
and outside of the filter using a soft brush or
vacuum hose to remove hair, dust, and large
particles. Do not clean the filter with water or
other liquids.
Resetting the Check Filter
Indicator
Reset the Check Filter Indicator when:
A. lights up.
1. Replace the filter.
2. Turn on the air purifier.
3. Press and hold
4. will turn off when successfully
reset.
B. The filter was changed before
up.
1. Press and hold
This will turn on
2. Press and hold
seconds.
3. will turn off when successfully
reset.
for 3 seconds.
lit
for 3 seconds.
.
again for 3