6x long red
flashing
1x orange
and 1 x green
lighting (after
inserting bat-
teries)
8
Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the wall-mount remote
control, please proceed as follows:
•
To remove the remote control (B) from the frame,
take hold of the sides of the remote control and
pull it out (see figure 5).
•
Remove the (old) batteries.
•
Insert the batteries ensuring that the polarity is
correct (see figure 6) while pressing and holding
down the system button (D) for 4s at the same
time, until the LED will quickly start flashing or-
ange (see figure 7).
•
Release the system button again.
•
Press and hold down the system button again for
Device defec-
tive
Test display
Restore factory settings
Please see your app
for error message or
contact your retailer.
Once the test
display has stopped,
you can continue.
43