HomeMatic IP HMIP-WRC2 Montage- Und Bedienungsanleitung Seite 33

Homematic IP Access Point first.
To teach-in the wall-mount remote control, please pro-
ceed as follows:
• Open the Homematic IP app on your smartphone.
Select the menu item "Teach-in device".
•
To remove the remote control (B) from the frame,
•
take hold of the sides of the remote control and
pull it out (see figure 5).
• Turn over the remote control.
• Insert two new 1.5 V LR03/micro/AAA batteries
into the battery compartment, making sure that
you insert them the right way round (see figure 6).
Teach-in mode remains activated for 3 minutes.
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button
(D) shortly (see figure 7).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED lights up
green. The device is now ready for use.
Start-up
33