Trouble Shooting; Service - Swim & Fun 1927 Benutzerhandbuch

UK
5.

Trouble shooting

Problem
At start the pump
is running but not
pumping water into
the pool.
Pressure is to low
Leaking filter con-
nection (between
filter and top valve)
The pump is not
running
Repairs of the filter and pump may only be performed by a qualified, professional firm.
Otherwise, the warranty will be void.
6.

Service

We have specialist knowledge of our products and the field in general, so you can get help
quickly and easily. If you have any questions or need more information, please feel free to
call
Customer service on +45 70 22 68 56
If you need service or to make a warranty claim, you must create a case directly in our
support system. Go to the home page under SUPPORT.
60
MV-1927-1928-A5-Filtersystem_BOOK.indb 60 MV-1927-1928-A5-Filtersystem_BOOK.indb 60
Cause
Air trapped inside suction
hose.
Pump is not placed at
ground level of the pool.
No water passage through
hoses?
Suction hose/skimmer
basket/pump or filter to
valve can be blocked by
leaves or debris
Damaged gasket or sand
The filter system has been
deactivated by the filter
timer or a filter control.
The plug is not connected.
The HFI device turns the
pump off.
Damaged pump motor.
MV-1927/1928-4-2020 swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS
Solution
The pump must be located at
ground level below the water
line!
Prime the hoses.
Clean suction hose/pool skim-
mer and top valve. Check fee-
ding hose connections for air.
Inspect the gasket and replace
with a new one if necessary.
Examine the settings.
Connect the plug.
Turn on the HFI device again.
If it immediately turns itself off
again this means that the pump
or the HFI device is damaged.
Replace the pump.
23-Apr-20 10:42:45 23-Apr-20 10:42:45